The front and rear panel LEDs provide status information for the health of the Sensor and the activity on its ports. The following
table describes the NS-series LEDs.
Front panel LEDs
LED Status Description
Status Green
Amber
Sensor is operating in good
health. it also indicates system
bad health.
Sensor is booting up. (It could
also indicate a system failure.)
Fan Green
Amber
All the fans are operating.
One or more fans are not
working.
Temp Green
Amber
Inlet air temperature measured
inside the chassis is normal.
(Chassis temperature OK)
Inlet air temperature measured
inside the chassis is too high.
(Chassis temperature too hot)
Gigabit Ports Act Blinking Amber
O
Data is received or transmitted.
No data is being transferred.
Gigabit Ports Link Green
O
The link is up.
The link is down.
Normal/Bypass Green
O
The port pair is in Inline Fail-
Open/Inline Fail-Close/SPAN/Tap
Mode.
The Port Pair is in the Bypass
Mode.
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS7x00 Sensors5
202
To Next Page