EasyManua.ls Logo

Trellix NS Series - Page 191

Default Icon
309 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
•
•
•
The Fail-Open Kits minimize the potential risks of in-line Sensor failure on critical network links. You need to purchase these kits
separately. Both copper and optical versions of the kit are available for the one-gigabit ports. The standard Gigabit Fail-Open Kits
and 10 Gigabit Fail-Open Kits are available for the 1 and 10 gigabit ports respectively.
The Monitoring ports of the Sensors can be fail-close; thus, if the Sensor is deployed in-line fail-close, a hardware failure results in
network downtime. Except the built-in RJ-45 ports which come with built-in fail-open functionality, you use the optional external
bypass switch provided in an Active Fail-Open Kit for the Monitoring ports to fail-open.
While the Sensor is operating, the Active Fail-Open (AFO) kit is in-line and routes all trac directly through the Sensor. When
the Sensor fails, the switch automatically shifts to a bypass state; in-line trac continues to ow through the network link but is
no longer routed through the Sensor. After the Sensor resumes normal operation, the switch returns to the "inline" state, once
again enabling in-line monitoring. The port pairs with AFO kits resume inline mode after a Sensor resumes normal operation or
is in good health.
G0 supports passive fail-open mode with RJ-11 port control
G0 also supports active fail-open using a Copper and Fiber 1/10 Gigabit AFO kit.
G1 and G2 supports built-in fail-open and active fail-open mode for these interface modules:
4-port 10 GigE/1 GigE LR Optical with internal fail-open
4-port 10 GigE/1 GigE SR Optical 50 micron with internal fail-open
4-port 10 GigE/1 GigE SR Optical 62.5 micron with internal fail-open
4-port RJ-45 10 GigE with internal fail-open
6-port RJ-45 1 GigE with internal fail-open
All RJ-45 ports support active fail-open using only a Copper AFO kit.
8-port SFP/SFP+ 1/10 Gigabit
The 8-port module supports active fail-open using a Copper and Fiber 1/10 Gigabit AFO kit.
G3 supports both internal fail-open and active fail-open mode when connected to an Active Fail-Open (AFO) kit
| NS7x50 Sensors4
Trellix Intrusion Prevention System NS-series Sensor Product Guide
191
Note
Note
Note

Table of Contents