Trocen AWC7813 - Page 10

AWC7813 motion controller user manual
WWW.SZTROCEN.COM
9
3.22 Cut Box
.........................................................................................................
81
3.23 Axis Reset
......................................................................................................
82
3.24 Key Moving
...................................................................................................
83
3.25 Z AutoFocus, X＆Y to Origin and Continue to Previous Work
......................
84
3.25.1 Run Z AutoFocus function
.................................................................
84
3.25.2 Set X&Y to Origin
...............................................................................
85
3.25.3 Continue to Previous Work
...............................................................
86
4. Frequently Asked Questions
.....................................................................................
88
4.1 What kind of U disk can the system read?
.....................................................
88
4.2 Why does the prompt "Engrave beyond border limit!" appear
.....................
89
4.3 Why does the prompt "Beyond border limit! Continue?" appear
.................
89
4.4 Why does the prompt " Beyond border limit!" appear
.................................
92
4.5 Why does the prompt "Trigger limit!" appear
...............................................
93
4.6 Why does the prompt " No file!" appear
.......................................................
94
4.7 Why does the prompt "To select the file!" appear
........................................
95
4.8 Why does the prompt "Continue to work?" appear
......................................
95
4.9 Why does the button movement speed slow down after turning on the
rotary engraving function?
...................................................................................
96
4.10 Why does the prompt "water protect!" appear
...........................................
96
4.11 Why does the prompt "opened protected!" appear
...................................
97
5. Operation process description
...............................................................................
100
5.1 Machine installation and debugging process
...............................................
100
5.2 Basic steps of using the laser machine to cut graphs
...................................
101