AWC7813 motion controller user manual
3.14.1.2 Cut Jerk
（1）Definition
The amount of change in acceleration during cutting. The larger the setting of
【Cut jerk】, the faster the overall cutting speed, and the larger the machine jitter,
the worse the cutting effect. The unit is mm/s3.
（2）Value Ranges
The value range is 1-20, and the default value is 8. The value increases or
decreases in units of 1.
3.14.1.3 Space Jerk
（1）Definition
When the laser head does not emit light, the amount of change in acceleration
during movement. the greater 【 Space Jerk 】 , the faster the idling speed of the
machine. At the same time, it may cause: Jitter occurs when a machine finishes
cutting a graph and starts cutting the next graph. The unit is mm/s3.
（2）Value Ranges
The value range is 1-20, and the default value is 10. The value increases or
decreases in units of 1.
3.14.1.4 Min Acc
（1）Definition
The minimum amount of change in the speed of the laser head during the
movement, that is, the acceleration of the laser head when it starts or turns. The unit
is mm/s2.
（2）Value Ranges
The value range is 100~800, and the default value is 300. Generally, you can
To Next Page
Loading...
