turck TBPN-L1-FDIO1-2IOL - 5 IO-Link - Functions for Acyclic Communication; General; Port Functions for Port 0 (IO-Link Master); Subindex 64: Master Port Validation Configuration

35
V01.0| 2017/04

TBPN-L1-FDIO1-2IOL - Standard IO-Link
5 IO-Link – functions for acyclic communication
5.1 General
The acyclic access to the data of IO-Link devices is realized via IO-Link CALLs.
Therefore it is necessary to distinguish between data of an IO-Link master or of an IO-Link device.
The addressing of the IO-Link CALL is realized via the so called Entity_Port- It defines which device
is addressed via the CALL:
Entity_Port 0 = IO-Link master module (IOLM)
Entitiy_Port 1 = IO-Link device at 1st IO-Link channel (IOL1)
Entitiy_Port 2 = IO-Link device at 2nd IO-Link channel (IOL2)
5.2 Port functions for port 0 (IO-Link master)
5.2.1 Subindex 64: Master Port Validation Configuration
Entity_
Port
IO-Link
subindex
Read
Write
Length Description
0 64 w max. 72 byte This object serves for writing a defined config-
uration of the IO-Link ports into the master.