Configuring with Turck Safety Configurator
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
44
7.6.1 Adapting the monitor settings
The dialog box "Monitor settings" is used to enter the basic data for the new configuration.
Fig. 20: Monitor settings
h Enter the configuration title in the register t
ab "Monitor information".
h Select the device type of the sa
fety module (safety monitor) in the section "Function range".
h If no monitor is detected, open the
settings for the interface to the connected device via the
"Interface..."-button and enter the IP address of the connected device under "UDP".
Fig. 21: Interface configuration
h If the IP-address of the device is no
t known, search the network via the "..."-button.
To Next Page
Loading...
