turck TBPN-L1-FDIO1-2IOL - Status and Control Word; Status Word; Control Word; Reset Device to Factory Settings

Operating
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
68
8.2 Status and control word
8.2.1 Status word
The status word is mapped into the module's process data.
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
1
- DIAG
0 - FCE - - - COM V1 -
Name Value Description
COM 0 -
1 Internal error, the device-interna
l communication is disturbed.
DIAG 0 -
1 Diagnostics available at the device.
FCE 0 -
1 The Force Mode is activated, which means, the actual output values may no
match the
ones defined and sent by the field bus.
V
1
0-
1 System power supply too low (< 18 V DC).
8.2.2 Control word
The control is not in use.
8.3 Reset device to factory settings
8.3.1 Device behavior
Resetting the device sets the complete device back to factory settings. The content of a plugged
memory stick is deleted as well (see
Storing a configuration (page 27)).