9
V01.00| 2017/04
TBPN-L1-FDIO1-2IOL- Safe I/O channels
2 Safety
2.1 Introduction
Please read this section carefully. Safety aspects cannot be left to chance when dealing with electri-
cal equipment.
This manual includes all information necessary for the prescribed use of TBPN-L1-FDIO1-2IOL. It has
been specially conceived for personnel with the necessary qualifications.
2.2 Intended Use
The safe hybrid safety module is a fieldbus module for a PROFINET safety PLC with PROFIsafe. It can
be used in applications:
up to SIL 3 (according to IEC 61508)
up to SIL CL3 (according to EN 62 061)
up to Category 4 and Performance Level e (according to EN ISO 13 849-1)
The module serves for controlling signal devices as for example emergency stop buttons, position
switches or OSSDs which are used to ensure human, material or machine protection.
Read these instructions carefully before using the product. This is to avoid possible damage to per-
sons, property or the device.
2.3 General notes regarding the use of the device
The Performance Level as well as the safety category according to EN ISO/ISO 13849-1 depend
on the external wiring, the application, the choice of the control devices as well as their arrange-
ment on the machine.
The user has to execute a risk assessment according to EN ISO/ISO 12100.
Based on the risk assessment a validation of the complete plant/machine has to be done in accor-
dance with the relevant standards.
Operating the device beyond the specification can lead to malfunctions or to the destruction of
the device.
Observe the installation hints.
For the release of safety circuits in accordance with EN/IEC 60204-1, EN ISO/ISO 13850 only use
the output circuits of connectors C2, C3, C4, C5 and C7.
Use the yellow connectors C0 to C3 only for the connection of sensors and actuators in safety-
related applications.
To Next Page
Loading...
