turck TBPN-L1-FDIO1-2IOL - V01.00| 2017;04

3
V01.00| 2017/04

TBPN-L1-FDIO1-2IOL- Safe I/O channels
6.1.3 Operation of the device at the PLC 40
7 Configuring with Turck Safety Configurator 41
7.1 Installing the software 41
7.2 Integrate Turck Safety Configurator in TIA/Step7 41
7.3 Licensing the software 42
7.3.1 Software incensing for virtual machines (VM) 42
7.4 Starting the software 42
7.5 Setting up a new configuration 43
7.5.1 Adapting the monitor settings 44
7.6 Set up a standard configuration 46
7.6.1 Standard configuration 47
7.7 Checking the configuration 47
7.8 Loading the configuration into the safety module 48
7.8.1 Change password 48
7.9 Checking the configuration 48
7.9.1 Loading the diagnostics configuration 50
7.10 Customize the configuration 50
7.10.1 Customizing a standard application (preliminary considerations): 50
7.10.2 Set up an own configuration 52
7.10.3 Deleting OSSDs 53
7.10.4 Add emergency shutdown in 64. OSSD 55
7.10.5 Light grid (AOPD) in 63. OSSD 55
7.10.6 Switch on non-safety channels permanently (1. and 2. OSSD) 57
7.10.7 Switch off of FDX4/5 if emergency shutdown or light grid activated 58
7.10.8 Switch off FDX6/7 at C3 (4. OSSD), if output FDX4/5 is switched. 60
7.10.9 Release of the safety function via a release bit in the F-CPU 61
7.10.10 Adding the device via GSDML 62
7.10.11 Setting the F_parameters 64
8 Operating 65
8.1 LED displays 65
8.1.1 Error LED (ERR) 65
8.1.2 BUS-LED 66
8.1.3 Channel-LEDs 66
8.2 Status and control word 68
8.2.1 Status word 68
8.2.2 Control word 68
8.3 Reset device to factory settings 68