Configuring with Turck Safety Configurator
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
52
7.11.2 Set up an own configuration
h Adapt the standard configuration of the safety channels in the Turck Safety Configurator under
"Monitor settings o Local I/O".
Fig. 31: Customized configuration of the local I/O
h Close the dialog box with "OK".
¬ The configuration change is done.
¬ The software generates the new release circuits (OSSDs) if
the following dialog box is closed with
"yes".
¬ Again, the PROFIsafe in- and output bits are automatically assigned.
NOTE
Release circuits (OSSDs) which are no longer used, have to be deleted.
To Next Page
Loading...
