Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
48
7.2 Start-up: IO-Link-Device with IO-Link V1.1
In general, the following applies:
The data storage of the master should be cleared before a device with a different device type is
connected to an IO-Link port which has already been used before.
To do so, set the master back to factory
settings or clear the data storage buffer using the param-
eter "data storage mode"
Start-up steps (1st possibility)
Fig. 11: Reset device to factory settings via DTM
h Reset the device to factory settings.
¬ the device is reset automatically.
h Connect the IO-Link V1.1 device.
¬ LED "IOL" = GREEN (for the respective port), IO-
Link communication is active
ATTENTION!
Resetting the device sets the complete device back to factory settings. The content of a
plugged memory stick is deleted as well (see Storing a configuration (page 27)).
.
To Next Page
Loading...
