31
V01.00| 2017/04
TBPN-L1-FDIO1-2IOL- Safe I/O channels
4 Mounting and connecting
4.1 Mounting
Mount the device on a pre-drilled and grounded mounting surface.
The mounting screw connects the functional earth with FE, if the mounting surface is
grounded.
ATTENTION!
Mechanical stress in the device
Danger of material damage
h
Mount the device onto an even mounting surface. Mounting the device on uneven surfaces may
cause mechanical stress in the housing.
4.1.1 Mounting material
2 mounting screws (M6)
The length of the mounting screws depends on the way of mounting and the mounting surface
ATTENTION!
Wrong mounting screws
Danger of material damage
h
Select the mounting screws always according to the quality of the mounting surface.
.
4.1.2 Mounting the device
h Adjust the module and fix it with 2 mounting screws (M6).
The maximum tightening to
rque is 1.5 Nm.
¬ The lower mounting screw connects the functional earth with FE at the device.
Fig. 11: Mounting the device
218 [5.58]
M6 (2x)
max. 1.5 Nm
To Next Page
Loading...
