Safety
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
10
2.4 Residual risks (EN ISO/ISO 12100-1)
The wiring proposals described in the following have been tested under operational conditions
with the greatest care. Together with the connected periphery of safety related equipment and
switching devices they fulfill relevant standards.
Residual risks remain, if
1
the proposed wiring concept is changed and connected safety related devices or protective devices
are possibly not or insufficiently included in the safety circuit.
2 the operator does not observe the relevant safety regulations specified for the operation, adjust-
ment and maintenance of the machine.
Here, the inspection and maintenance intervals for the machine should be strictly observed.
Failure to follow these instructions can result in serious injury or equipment damage.
2.5 Foreseeable misuse
The safety module is not suitable for:
the use in explosive areas
outdoor use
the permanent use in liquids
Modifications to the device
It is not permitted to modify the technical function or the construction of the device.
2.6 Proper and safe operation
Appropriate transport, storage, deployment and mounting as well as careful operating and thor-
ough maintenance guarantee the trouble-free and safe operation of these devices.
2.6.1 Notes concerning planning/installation of this product
All respective safety measures and accident protection guidelines must be considered carefully and
without exception.
2.7 Warranty and liability
Any liability and warranty are excluded in case of
improper application or not intended use of the product
non-observance of the user manual
mounting, installation, configuration or commissioning by unqualified persons.
To Next Page
Loading...
