35
V01.00| 2017/04
TBPN-L1-FDIO1-2IOL- Safe I/O channels
4.3.3 Connect the M12 connectors
When connecting the cables to the M12-connectors, please use the torque screwdriver mentioned
below.
M12 mounting tool
Description Technical data Ident no.
Torque screwdriver,
Torque range 0.4}1.0 Nm
– M8 (SW9)
– M12 for bus cables (SW13)
– M12 for sensor cables (SW14)
Torque-Wrench-Set-
Bus
6936171
Connecting Ethernet
We recommend pre-assembled 4-pole Ethernet cables according to
ISO/IEC 11 801, CAT 5E.
Admissible tightening torque: 0.6 Nm
Suitable cables can be found on www.turck.de under "Products o Fi
eldbus technology o
Accessories".
Connect sensors/actuators
We recommend pre-assembled 5-pole sensor cables.
Admissible tightening torque: 0.8 Nm
Suitable cables can be found on www.turck.de under "Products o Fi
eldbus technology o
Accessories".
To Next Page
Loading...
