81
V01.00| 2017/04
TBPN-L1-FDIO1-2IOL- Safe I/O channels
9 Restarting after device exchange/modification
9.1 Changing a TBPN-L1-FDIO1-2IOL
9.1.1 Prerequisites
The replacement device has to be a device of the same type with the identical or a higher device
version.
Ensure, that the parameterization and the configuration of the exchange devices exactly corre-
sponds to the parameterization and the configuration of the device to be changed.
Please follow the description under chapter 3.10.5, Module behavior/configuration transfer to
transfer an existing configuration from the configuration memory of the original device into the
exchange device.
9.1.2 Dismounting the device to be exchanged
Dismount the TBPN-L1-FDIO1-2IOL as described in chapter 10, Maintenance, repair, decommis-
sioning and disposal.
9.1.3 Mounting the exchange device
Mount the exchange device as described in chapter 4.1, Mounting.
9.1.4 Putting the exchange device into operation
Put the exchange device into operation as described in chapter 6.1, Initial commissioning.
9.1.5 Disposing devices
Defective or faulty devices must not, in any event, be put back into circulation.
ATTENTION!
Mounting/dismounting under voltage
Personal damage due to unintentional machine start
h Mount or unmount the device only in a de-energized condition.
To Next Page
Loading...
