turck TBPN-L1-FDIO1-2IOL - Page 5

3
V01.00| 2017/04
TBPN-L1-FDIO1-2IOL
7.5.1 Adapting the monitor settings 44
7.6 Set up a standard configuration 46
7.6.1 Standard configuration 47
7.7 Checking the configuration 47
7.8 Loading the configuration into the sa
fety module 48
7.8.1 Change password 48
7.9 Checking the configuration 48
7.9.1 Loading the diagnostics configuration 50
7.10 Customize the configuration 50
7.10.1 Customizing a standard applicatio
n (preliminary considerations): 50
7.10.2 Set up an own configuration 52
7.10.3 Deleting OSSDs 53
7.10.4 Add emergency shutdown in 64. OSSD 55
7.10.5 Light grid (AOPD) in 63. OSSD 55
7.10.6 Switch on non-safety channels permanently (1. and 2. OSSD) 57
7.10.7 Switch off of FDX4/5 if emergency shutdown or light grid activated 58
7.10.8 Switch off FDX6/7 at C3 (4. OSSD), if output FDX4/5 is switched. 60
7.10.9 Release of the safety function via a release bit in the F-CPU 61
7.10.10 Adding the device via GSDML 62
7.10.11 Setting the F_parameters 64
8 Operating 65
8.1 LED displays 65
8.1.1 Error LED (ERR) 65
8.1.2 BUS-LED 66
8.1.3 Channel-LEDs 66
8.2 Status and control word 68
8.2.1 Status word 68
8.
2.2 Control word 68
8.3 Reset device to factory settings 68
8.3.1 Device behavior 68
8.4 Mapping 69
8.4.1 Overview - entire module 69
8.4.2
Process input data - Safe I/O channels 70
8.4.3 Process input data - Universal standard I/Os 73
8.4.4 Process input data – IO-Link master channels 74
8.5 Process output data 75
8.5.1 Overview - entire module 75
8.5.2
Process output data - Safe I/O channels 77
8.5.3 Process output data - Universal standard I/Os 79
8.5.4 Process output data – IO-Link master channels 79