options, the display adjusts to the highlighted contrast level; press YES when you see the
display contrast you want to use.
Set C-CH Output
Choose how you want the scanner to handle control channel data:
● Off : The scanner will not output the control channel data.
● On : The scanner will output the control channel data.
● Extend : The scanner will output the control channel data along with any
description.
Set GPS Format
Configure how the scanner displays position coordinates, time, and units during GPS
operation:
Set Pos Format
Select how the scanner displays longitude and latitude:
● DMS: DDD° MM' SS.ss : Display coordinates in degrees (DDD), minutes (MM),
and seconds (SS.ss).
● DEG: DDD.dddddd : Display coordinates as decimal degrees.
Set Time Format
Select 12H for 12-hour (am/pm) time format or 24H for 24-hour time format.
Set Time Zone
Set the number of hours your local time zone differs from universal time (GMT/UTC).
Select from -14 hours to +14 hours in half-hour (0.5 h) increments.
Set Unit
Select the unit used for distance: mile or kilometer (km).
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/Settings.html (4 of 6)5/26/2009 11:16:37 AM
To Next Page
