Close Call Priority mode
In Close Call Priority, the scanner interrupts its current operation every 2 seconds,
searches for signals that are stronger than other signals on the selected band, then returns
to the previous operation. When it detects a close call hit, the scanner can switch to the
channel and open squelch (depending on the setting). In Close Call DND (do-not-
disturb) mode, the scanner only interrupts if it is not already receiving audio.
For more information about key operation and other specifics about Close Call mode:
● BCD396XT or BC346XT: Handheld Scanner Close Call Mode
● BCD996XT: BCD996XT Close Call Mode
● BCT15X: BCT15X Close Call Mode
To enter Close Call mode on the BCD396XT or BC346XT, FUNCTION
+ repeatedly tap HOLD until Close Call Pri appears.
To enter Close Call mode on the BCD996XT, repeatedly tap the SQ knob
until Close Call Pri appears.
To enter Close Call mode on the BCT15X, Function + repeatedly tap the
SQ knob until Close Call Pri appears.
The Close Call icon appears for Close Call Priority mode and is in reverse
colors for Close Call DND mode.
Close Call Only mode
The scanner stops the current operation and only performs Close Call checks as
described above.
For more information about key operation and other specifics about Close Call Only
mode:
● BCD396XT or BC346XT: Handheld Scanner Close Call Only Mode
● BCD996XT: BCD996XT Close Call Only Mode
● BCT15X: BCT15X Close Call Only Mode
file:///C|/Documents%20and%20Settings/POpitz/My%20D.../CDImage_090515/Manual/AvailableOperationModes.html (3 of 8)5/26/2009 11:12:22 AM
To Next Page
Loading...
