Uniden BCD396XT - Priority Plus Scan; Key Operation During Priority Scan

Thursday, May 14, 2009
132
Priority Plus Scan
This works in Scan Mode or Scan Hold Mode when the setting of Priority Scan is Plus On. In this condition,
the "PRI" icon blinks and the scanner scans only Priority Channels.
If there is no Priority Channel or all Priority Channels are locked out, the scanner displays "Priority Scan No
Channel" and sounds an Error Tone. Then Priority Plus Scan stops.
Press any key to cancel it. Priority Scan is turned off automatically and it starts normal scanning.
Key Operation During Priority Scan
Key operations are the same as in Scan Mode and Scan Hold Mode.
See: Key Operation During Scan and Key Operation During Scan Hold Mode.
PRI
System 1 C
SCAN ↑
S0: 1 2 * * 5 * 7 8 * 0
GRP 1 2 - - - 6 - - - 0