Thursday, May 14, 2009
PRIORITY ID SCAN
Refer to Set Priority to set Priority Channels. Refer to Priority ID Scan for activation of Priority ID Scan.
Priority ID Scan
Priority ID Scan works in ID Scan/Search Mode or ID Scan/Search Hold Mode when the Priority ID Scan
setting is on.
This works on Motorola and EDACS (Wide, Narrow), and LTR Systems.
This function is very similar to conventional priority although there is no “interrupt” during the
transmission. Priorities are checked in between transmissions, when the scanner is receiving the control
channel, as during the channel delay period.
Motorola system can receive priority IDs while the scanner is on the voice channel. However, for this to
work, the channel must also be assigned as a priority channel by the radio system (otherwise, the TGID will
never be sent on the voice channel’s low-speed data).
HOLD
Si te 1- 1 MOT
I D: 16524
P 851. 0125
S0: 1 2 * * 5 * 7 8 * 0
GRP 1 2 - - - 6 - - - 0
The scanner can only look for priority channels on the trunked system it is currently scanning and only
responds if the priority channel is unlocked..
The within the system, channels in channel groups with GQK 1 are treated with highest priority, followed
by 2, 3, … 9, 0.
Key Operation During Priority ID Scan
Key operations are same as in ID Scan Mode and ID Scan Hold Mode.
See: Key Operation During Scan and Key Operation During Scan Hold Mode.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
