191
Hold Mode
You can monitor frequency displayed in this mode.
The scanner displays "HOLD".
Center frequency icon and bars do not blink different from Search or Max Hold Search Mode.
You can select the frequency to monitor by moving the marker pointer.
Turn Scroll Control, the marker changes the frequency every step.
Turn Scroll Control in Function Mode, the marker changes the frequency every bar.
Press [Hold / ] in Search Mode or Max Hold Search Mode to go to this mode.
General Operation
Normal Screen
This screen is usually displayed in Band Scope Mode.
This screen displays the start and end frequency of the range on the bottom line.
You can control the marker to monitor a frequency in Hold Mode and register the marker frequency as
the center frequency.
Setting Screen
This screen is displayed to operate the band scope settings.
This screen displays center frequency of the range, search step and span of the range on the bottom
line.
You can change these parameters.
Press [. / no / pri] while on the normal screen to display this screen.
In this screen, press [. / no / pri] to select the next setting item.
The icon of the selected item blinks.
You can change the selected item’s parameter (except “CF”) by turning the Scroll Control.
When the “CF” is selected, go to the edit frequency menu to change the center frequency by pressing [E
/ yes / gps]. (See Edit Frequency.)
If you change a parameter, the scanner clears the search result and searches again.
The scanner returns to a normal screen 10 seconds after the last operation or by pressing [L/O].
Function Mode
Press [FUNC] to go to Function Mode and display the modulation, the attenuator and IF Exchange.
Restart Searching
This function is used to clear the search result and search again.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
