Thursday, May 14, 2009
Key Operation During Scan
Normal Mode
[Scroll Control] knob
Turn this knob to resume scanning while monitoring.
Turn this knob to change the scan direction. If the scanner is scanning system scan, service search, then
custom search turn this knob counterclockwise to scan custom search, service search, then system scan.
[Scan / srch] key
Press this key to resume scanning while monitoring.
[Hold / ] key
Press this key to go to Scan Hold Mode.
Long press this key for System Hold Mode.
In System Hold Mode, long press this key for full system scan.
[L/O] key
Press this key once to temporarily lock out the monitored channel or TGID (in ID Search Mode). When the
scanner is turned off, the channel or TGID is unlocked.
Press this key twice within one second to lockout the monitored channel or TGID (in ID Search Mode).
When the scanner is turned off, these lockouts remain.
Long press this key to unlock all channels and TGIDs in the current system when the scanner is receiving a
signal.
[1 – 9, 0] key
Press these keys to enable or disable SQKs.
[. / no / pri] key
Press this key to go to the mode that selects the ten’s place for SQKs, then press the number key to jump
to the ten’s place.
[E / yes / gps] key
Press this key to edit the data for the current channel.
If the current system is a protected system, the scanner displays the “Protected System Access Not
Allowed Press Any Key” and sound an error tone.
[MENU] key
Press this key to go to the Menu Mode at Top Menu.
Function Mode
F+[Scroll Control] knob
Turn this knob to select a system quickly. The scanner will start scanning from the selected system.
To Next Page
Loading...
