Uniden BCD396XT - Tone-Out Mode; Display During Tone-Out Mode

Thursday, May 14, 2009
172
TONE-OUT MODE
Select “Tone-Out Standby” in Tone-Out for …
Note: In this function, Close Call and WX Priority don't operate.
Display during Tone-Out Mode
Tone-Out Standby
FM : These icons show the modulation type.
ATT : This icon shows the attenuator status of the current channel. When Global attenuator is
on, this icon blinks.
I FX : This icon shows when the current channel is an IF exchange frequency.
Tone-Out Search
FM : These icons show the modulation type.
ATT : This icon shows the attenuator status of the current channel. When Global attenuator is
on, this icon blinks.
I FX : This icon shows when the current channel is an IF exchange frequency.
Tone- Out Search
Tone- Out 1
FM ATT I FX CH1
A : 0. 0Hz
B : 0. 0Hz
This shows Tone-Out Search Status.
This shows Tone-Out channel name.
This shows Tone-Out channel number.
Tone A = Tone B = 0.0 Hz
Tone- Out Standby
Tone- Out 1
FM ATT I FX CH1
A : 1000. 0Hz
B : 2000. 0Hz
This shows Tone-Out Standby Status.
This shows Tone-Out channel name.
This shows Tone-Out channel number.
This shows Tone A and B frequency.