Uniden BCD396XT - Page 1027

BC346XTHoldMode < UnidenMan4 < TWiki
Tap Enter Scan
mode.
Enter the number on the key.
FUNCTION
+ Tap
Enter Search
mode.
Switch to an
alternate
intermediate
frequency to
avoid
interference.
Change the
volume offset for
the current
signal.
Rotate through
the three
available display
modes.
Key Name
(2nd
operation)
Action on:
Lockout
7 (Attenuation)
8 (Reverse
freq.)
9 (Modulation)
Tap Unlock (if
locked) or
Temporary
Lockout (double
tap for
permanent
lockout) the
current channel
or frequency.
Enter the number on the key.
FUNCTION
+ Tap
Unlock (if
locked) or
Temporary
Lockout (double
tap for
permanent
lockout) the
current system,
site, or search.
Toggle the
attenuator state
for the current
signal.
NA Change the
modulation type.
FUNCTION
+ Press &
hold
Unlock all
systems, sites
and searches.
Toggle the
attenuator state
for all signals.
Switch to the
reverse repeater
frequency of the
current signal.
NA
file:///C|/Documents%20and%20Settings/POpitz/My%20...ts/temp/CDImage_090515/Manual/BC346XTHoldMode.html (2 of 6)5/26/2009 11:16:46 AM