State-by-State Scanning
The BCT15X comes preprogrammed with many of the channels used by local police,
department of transportation, and highwaypatrol agencies, organized by state. You can
also assign a state to the systems you program so that they can be included in State-by-
State scanning.
Selecting your State
To select your state, tap FUNCTION (the scroll knob) then tap the Volume control.
Rotate the scroll knob to select your state, then press E to make your selection. The
scanner unlocks any systems you have set to the selected state, locks out systems that are
set to a different state, and uses the current state preprogrammed data during state-by-
state scanning.
Using the Built-In State-by-State Agencies
To use the built-in State-by-State agencies, repeatedly tap DOT/POL/PRI and (Bear
Paw)/HP/ALT until the desired agency type's icon shows in the bottom row of the
display:
PL — Local Police
DT — Department of Transportation
HP — Highway Patrol
BT — BearTracker Warning System
After scanning your programmed systems, the BCT15X will scan the enabled state-by-
state agencies, then resume scanning your programmed systems.
This page applies to the following scanner(s): BCT15X Users
Guide
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/StatebyStateScanning.html5/26/2009 11:12:55 AM
To Next Page
Loading...
