Uniden BCD396XT - Page 292

Thursday, May 14, 2009
43
P25 Waiting Time
The feature is used to set a wait time for P25 decode. After receive a transmission the scanner will wait for
the set duration to check if there is any P25 signal.
Selectable waiting times are:
0 ms
100 ms
200 ms
300 ms
400 ms
500 ms
600 ms
700 ms
800 ms
900 ms
1000 ms
Press [E / yes / gps] to accept the selection and return to the previous menu.
P25 NAC Option
This menu is used to set P25 NAC (Network Access Code) option for the P25 One-Freq Trunk systems. You
can select from the following items.
Search The scanner search for all the P25 NAC.
Set P25 NAC The scanner uses the programmed P25 NAC
When you select “Search”:
The scanner returns to the previous menu.
When you select “Set P25 NAC”:
Press the number key to enter P25 NAC, valid range is from 0 to FFF hex.
Press [E / yes / gps] to set and return to the previous menu.
If out of range, the message “Out of Range” and “Press Any Key” will be shown with error tone.
Edit Site
See Program Site.
Edit Group
See Program Group.