Uniden BCD396XT User Manual

Thursday, May 14, 2009
53
Set Longi tude
00. 000000 W
Set Longitude
Press the number keys to enter longitude data. Press any number key when the cursor is in the last
position to toggle between east longitude (E) and west longitude (W).
Press [E / yes / gps] to accept and return to the previous menu.
If “DMS:DDD⁰MM’SS.ss” is selected in Set Pos Format, the display is the following.
If “DEG:DDD.dddddd” is selected in Set Pos Format, the display is the following.
Set Range
In this menu, the setting unit is determined by the setting in Set Unit.
When you select “mile” in Set Unit, the displayed unit will be mile.
When you select “km” in Set Unit, the displayed unit will be km.
The valid setting range is from 0.5 to 125.0, in 0.5 steps.
Press [E / yes / gps] to accept the setting and return to the previous menu.
Set GPS Enable
When this option is set to “On”, the scanner will control L/O status of this site by position information
received from a GPS.
On The L/O state of this site is automatically controlled by position information.
Off The L/O state of this site is not influenced by GPS.
Press [E / yes / gps] to accept and return to the previous menu.
Set Longi tude
00⁰00’ 00. 00 W

Uniden BCD396XT Specifications

General

Belt clip	Yes

Weight and Dimensions

Weight	907 g
Dimensions (WxDxH)	51 x 25 x 1152 mm