Thursday, May 14, 2009
Set Alert
Channel alert options can be set using this menu.
Set Alert Tone
Set Alert Light
Press [E / yes / gps] to enter the setting.
Set Alert Tone
You can select whether the scanner should sound an Alert Tone when this Channel becomes active*.
Off No alert sounds.
Alert 1-9 The scanner sounds Alert1-9 with the Channel becomes active.
If you select “Off”, the scanner returns to the previous menu.
If you select “Alert1-9”, the scanner goes to Alert Level selection.
Auto The alert is set to the same volume as normal audio.
Level1-15 The alert is fixed to the selected audio level.
Press [E / yes / gps] to accept the entry and return to the previous menu.
Set Alert Light
You can select whether the scanner should have an alert light when this Channel becomes active*.
Off
Blue
Red
Magenta
Green
Cyan
Yellow
White
If you select “Off”, the scanner returns to the previous menu.
If you select an alert light color, the scanner goes to the Alert Light Pattern selection.
On The alert light is set to on
Slow Blink The alert light blinks slowly
Fast Blink The alert light blinks fast
Press [E / yes / gps] to accept the entry and return to the previous menu.
*"Active" means that the scanner received a signal on the Channel in Scan Mode or Scan Hold Mode, or
the Channel is selected in Scan Hold Mode.
To Next Page
Loading...
