Uniden BCD396XT - Page 328

Thursday, May 14, 2009
79
Set Delay Time
This setting controls how long the scanner stays on frequencies after a transmission ends before resuming
searching.
Turn [Scroll Control] to select the delay time setting from the following list:
-10 sec
-5 sec
-2 sec
0 sec
1 sec
2 sec
5 sec
10 sec
30 sec
Then press [E / yes / gps] to accept and return to the previous menu.
Set Attenuator
You can select to attenuate RF reception on all frequencies in the search range.
On The frequencies are attenuated.
Off The frequencies are not attenuated.
Press [E / yes / gps] to accept the entry and return to the previous menu.
Set Audio AGC
When Audio AGC function is “On”, the scanner judges the volume level and changes the volume
automatically.
You can turn either Analog or Digital audio “On” or “Off”.
Analog : On / Off
Digital : On / Off
On Audio AGC is on.
Off Audio AGC is off.
Turn [Scroll Control] to focus the cursor on the item. Press [E / yes / gps] to change the setting on / off and
press [Menu] to return to the previous menu.