Uniden BCD396XT User Manual

Thursday, May 14, 2009
152
[1 - 3 / sr 1 - 3] key
Press this key to start searching the search range set at Set Search Key.
[4 / LEFT / ifx] Key
While monitoring a frequency, press this key to exchange IF(intermediate frequency).
[6 / RIGHT / disp] Key
Press this key to change the system ID display and system ID name display in custome search if C-Ch Only
Mode is on.
[7 / att] key
Press this key to toggle the attenuator state for the search range.
Long press this key to toggle global attenuator.
[8 / rev] key
Long press this key to show the reverse frequency for the current frequency.
And release this key to return to the current frequency.
[9 / mod] Key
Press this key to change the modulation.
[0 / WX] key
Press this key to change WX Alert Priority Mode.
Long press this key to start WX Scan.
[E / yes / gps] key
Press this key to change to the GPS Mode.
[MENU] key
Press this key to go to Search for... in Service Search and Custom Search.
Press this key to go to Srch/CloCall Opt in Quick Search.

Uniden BCD396XT Specifications

General

Belt clip	Yes

Weight and Dimensions

Weight	907 g
Dimensions (WxDxH)	51 x 25 x 1152 mm