241
The scanner returns only "," to punctuate for parameters which are not
appropriate the site type.
In set command, the scanner neglects the parameters that are not appropriate
the system type.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
When the system protect bit is ON, except [REV_INDEX], [FWD_INDEX],
[SYS_INDEX], [CHN_HEAD], [CHN_TAIL], other parameters will be send as a
reserve parameter in the Radio -> Controller command.
This command is only acceptable in Programming Mode.
<COMMAND MCP>
Get/Set Motorola Custom Band Plan
Controller → Radio
MCP,[INDEX][\r]
MCP,[INDEX],[LOWER1],[UPPER1],[STEP1],[OFFSET1],[LOWER2],[UPPER2],[STEP2],
[OFFSET2],[LOWER3],[UPPER3],[STEP3],[OFFSET3],[LOWER4],[UPPER4],[STEP4],
[OFFSET4],[LOWER5],[UPPER5],[STEP5],[OFFSET5],[LOWER6],[UPPER6],[STEP6],
[OFFSET6][\r],
Radio → Controller
MCP,[LOWER1],[UPPER1],[STEP1],[OFFSET1],[LOWER2],[UPPER2],[STEP2],
[OFFSET2],[LOWER3],[UPPER3],[STEP3],[OFFSET3],[LOWER4],[UPPER4],[STEP4],
[OFFSET4],[LOWER5],[UPPER5],[STEP5],[OFFSET5],[LOWER6],[UPPER6],[STEP6],
[OFFSET6][\r],
MCP, OK[\r]
[INDEX] : Site Index
[LOWER n] : Lower Frequency n
[UPPER n] : Upper Frequency n
[STEP n] : Step n
"500": 5.0k “625": 6.25k "1000": 10.0k
"1250": 12.5k "1500": 15.0k "1875": 18.75k
"2000": 20.0k “2500": 25.0k "3000": 30.0k
"3125": 31.25k "3500": 35.0k "3750": 37.5k
"4000": 40.0k "4375": 43.75k "4500": 45.0k
"5000": 50.0k "5500": 55.0k “5625": 56.25k
"6000": 60.0k "6250": 62.5k "6500": 65.0k
"6875": 68.75k "7000": 70.0k "7500": 75.0k
"8000": 80.0k “8125": 81.25k "8500": 85.0k
“8750": 87.5k "9000": 90.0k “9375": 93.75k
"9500": 95.0k "10000": 100.0k
[OFFSETn] : Offset n (-1023 to 1023)
Get/Sets Band Plan Setting for MOT 800 custom/VHF/UHF site.
In set command, if only "," parameters are send the Band Plan setting of the
site will not changed.
The set command is aborted if any format error is detected.
When the system protect bit is ON, all the parameters will be send as a
reserve parameter in the Radio -> Controller command.
Before using this command, user should set Band Plan type as “Custom” first
by using SIF command.
This command is only acceptable in Programming Mode.
To Next Page
