243
<COMMAND TFQ>
Get/Set Trunk Frequency Info
Controller → Radio
TFQ,[CHN_INDEX][\r]
TFQ,[CHN_INDEX],[FRQ],[LCN],[LOUT],[RSV],[NUMBER_TAG],[VOL_OFFSET], [RSV]
[\r]
Radio → Controller
TFQ,[FRQ],[LCN],[LOUT],[REV_INDEX],[FWD_INDEX],[SYS_INDEX],[GRP_INDEX],[RSV],
[NUMBER_TAG],[VOL_OFFSET],[RSV][\r]
TFQ,OK[\r]
[CHN_INDEX] : Trunk Frequency Index
[FRQ] : Trunk Frequency
[LCN] : LCN
(EDACS WIDE/NARROW system: 0 to 20
LTR system: 0 to 30)
[LOUT] : Lockout (0:Unlocked / 1:Lockout)
[REV_INDEX] : Reverse Frequency Index of the Site
[FWD_INDEX] : Forward Frequency Index of the Site
[SYS_INDEX] : System Index of the Frequency
[GRP_INDEX] : Index of the Site
[NUMBER_TAG] : Number tag (0-999 / NONE)
[VOL_OFFSET] : Volume Offset (-3 - +3)
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
For Motorola or EDACS SCAT System, [LCN] is ignored.
When the system protect bit is ON, except [REV_INDEX], [FWD_INDEX],
[SYS_INDEX], [GRP_INDEX], other parameters will be send as a reserve
parameter in the Radio -> Controller command.
[NUMBER_TAG] and [VOL_OFFSET] are just used for SCAT system.
<COMMAND AGC>
Append Channel Group
Controller → Radio
AGC,[SYS_INDEX][\r]
Radio → Controller
AGC,[GRP_INDEX][\r]
[SYS_INDEX] : System Index
[GRP_INDEX] : appended Channel Group Index
Append Channel Group to the system.
Returns "-1" if the scanner failed to create because of no resource.
This command is only acceptable in Programming Mode.
To Next Page
