251
<COMMAND LIN>
Get/Set Location Alert System Info
Controller → Radio
LIN,[INDEX][\r]
LIN,[INDEX],[LAS_TYPE],[NAME],[LOUT],[ALT],[ALTL],[LATITUDE],[LONGITUDE],
[RANGE],[SPEED],[DIR],[ALT_COLOR],[ALT_PATTERN][\r]
Radio → Controller
LIN,[LAS_TYPE],[NAME],[LOUT],[ALT],[ALTL],[REV_INDEX],[FWD_INDEX],[SEQ_NO],
[LATITUDE],[LONGITUDE],[RANGE],[SPEED],[DIR],[ALT_COLOR],[ALT_PATTERN] [\r]
LIN,OK[\r]
[INDEX] : Location Alert System Index
[LAS_TYPE] : Location Alert Type
(POI: POI / DROAD: Dangerous Road / DXING: Dangerous Xing)
[NAME] : Name (max.16char)
[LOUT] : Lockout (0:Unlocked / 1:Lockout)
[ALT] : Alert Tone (0:OFF/1 - 4:Tone No.)
[ALTL] : Alert Tone Level (0:AUTO/1-15)
[REV_INDEX] : Reverse System Index of Location Alert System
[FWD_INDEX] : Forward System Index of Location Alert System
[SEQ_NO] : Location Alert System Sequence Number
[LATITUDE] : North or South Latitude
[LONGITUDE] : West or East Longitude
[RANGE] : Range (1-80: 1=0.05 mile or km)
[SPEED] : Speed Limit (0-200: 1 means 1 mile/hour or km/h)
[DIR] : Heading (0-358/360 : 2' step, 360=All range)
[ALT_COLOR] : Alert Light color
(OFF,BLUE,RED,MAGENTA,GREEN,CYAN,YELLOW,WHITE)
[ALT_PATTERN] : Alert Light Pattern(0:ON / 1:SLow / 2:Fast)
Get/Set Location Alert System Information.
In set command, the scanner neglects the parameters that are not appropriate
the system type.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
To Next Page
