Thursday, May 14, 2009
Then press[E / yes / gps]. You are then prompted to set the detailed information of band plan.
Set Base Freq
Set Offset
Set Spacing
When you select “Set Base Freq”, you are then prompted to “Input Lower” then “Input Upper”. Use the
number keys and decimal key to input frequencies. Press [E / yes / gps] to set the frequency. If the entered
frequency is out of band, “Out of Band” will be shown with an error tone. Press any key to go back to
editing the base frequency.
When you select “Set Offset”, you can set the channel offset for the band plan entry. You can set the
Offset from -1023 to +1023. Enter the absolute value using the number keys. If you input a value over
1023, “Out of Range” and “Set Max? (Y/N)” will be shown. Press [. / no / pri] to return to editing state.
Press [E / yes / gps] to set the value to maximum number (1023) and you will be prompted to “Select
Polarity”. Select “+ Polarity” or “- Polarity”, then press [E / yes / gps] to confirm the setting.
When you select ”Set Spacing”, the following spacing values can be selected:
5.00 kHz 6.25 kHz 10.00 kHz 12.50 kHz 15.00 kHz
18.75 kHz 20.00 kHz 25.00 kHz 30.00 kHz 31.25 kHz
35.00 kHz 37.50 kHz 40.00 kHz 43.75 kHz 45.00 kHz
50.00 kHz 55.00 kHz 56.25 kHz 60.00 kHz 62.50 kHz
65.00 kHz 68.75 kHz 70.00 kHz 75.00 kHz 80.00 kHz
81.25 kHz 85.00 kHz 87.50 kHz 90.00 kHz 93.75 kHz
95.00 kHz 100.00 kHz
Turn the [Scroll Control] to select. Press [E / yes / gps] to set the Spacing.
Note: If Base Freqs haven’t been set yet, the setting of Offset and Spacing will not be accepted.
For rebanded systems, the most likely settings for Base (Lower and Upper), Offset and Spacing in the table
are:
Set Site Type
You can select the site type for EDACS WIDE/NARROW system.
Wide(Standard) EDACS wide site
Narrow EDACS narrow site
Press [E / yes / gps] to accept and return to the previous menu.
To Next Page
Loading...
