Uniden BCD396XT - Page 626

Thursday, May 14, 2009
68
Srch/CloCall Opt
This menu includes the following:
Freq Lockouts
Broadcast Screen
CTCSS/DCS Search
Repeater Find
Max Auto Store
Set Delay Time
Set Attenuator
Press [E / yes / gps] to go to each setting.
Each setting in these options is applied to some or all Search Modes*.
*”Search Mode” is Service Search, Custom Search, Quick Search, Search and Store, Close Call and CC Auto
Store.
The mode in which a setting is applied showed in the following table.
Service
Search*1
Custom
Search*1
Quick
Search
Search
and Store
Close
Call
CC Auto
Store
CC Hits
System
Band
Scope
Freq Lockouts
O
O
O
O
O
O
Broadcast Screen
O
O
O
*2
O
O
CTCSS/DCS Search
O
O
O
O
O
O
Repeater Find
O
O
O
Max Auto Store
O
O
Set Delay Time
O
O
O
Set Attenuator
O
O
O
O
*1
While searching a search range in Search with Scan, these settings are valid.
*2
In Search and Store, this setting is valid only when the scanner stores a Custom Search frequency.
Freq Lockouts
You can select from these items.
Unlock All
Rvw Search L/O
Press [E / yes / gps] to enter each menu.
Unlock All
Selecting this causes the scanner to prompt "Confirm?" and "Unlock All(Y/N)".
Press [E / yes / gps] to unlock all frequencies. Then the scanner returns to Freq Lockouts.
Press [. / no / pri] to cancel this and return to the previous menu.
Note: If no frequencies have been locked, the scanner displays "Nothing Locked".
Press any key to return to the previous menu.