Thursday, May 14, 2009
Set Each Band
You can turn on or off each of the following bands.
Pager : On/Off : Various, according to FCC allocation
FM : On/Off : 88.1000 - 107.9000 MHz
UHF TV : On/Off : 470.0000 - 512.0000 MHz
VHF TV : On/Off : 54.0000 - 72.0000 MHz
: 76.0000 - 88.0000 MHz
: 174.0000 - 216.0000 MHz
NOAA WX : On/Off : 161.6500, 161.7750, 162.4000,
162.4250, 162.4500, 162.4750,
162.5000, 162.5250, 162.5500,
163.2750 MHz
Band 1 : On/Off
Band 2 : On/Off
:
Band 10 : On/Off
On The scanner ignores hits on the band frequencies.
Off The scanner does not Screen for the band frequencies.
Turn [Scroll Control] to put the cursor focus on the band that you want to change, and press [E / yes / gps]
to change the setting.
Then press [Menu] to return to the previous menu.
Program Band
You can set up to 10 custom band screens. Select a band and press [E / yes / gps] to go to the limit setting.
You need to set a lower and upper limit frequency. First, enter the lower limit frequency and store it by
pressing [E / yes / gps]. Next, enter the upper limit frequency and press [E / yes / gps] to store the upper
limit. The scanner returns to the previous menu.
Note: If the lower frequency is larger than the upper frequency, the setting is automatically changed.
CTCSS/DCS Search
This option sets whether the scanner will search for a CTCSS/DCS code when it finds an active frequency.
Off The scanner does not search for CTCSS/DCS codes.
On The scanner searches for CTCSS/DCS codes. If the scanner detects the code, it
displays the found code.
Press [E / yes / gps] to set this setting and return to the previous menu.
Note: For AM, WFM or FMB modulation, this setting is ignored and the scanner treats this setting as “Off”.
To Next Page
Loading...
