Uniden BCD396XT - Page 803

245
<COMMAND SSP>
Get/Set Service Search Settings
Controller → Radio
SSP,[SRCH_INDEX][\r]
SSP,[SRCH_INDEX],[DLY],[ATT],[HLD],[LOUT],[QUICK_KEY],[START_KEY],[RSV],
[NUMBER_TAG],[RSV],[RSV],[RSV] [\r]
Radio → Controller
SSP,[SRCH_INDEX],[DLY],[ATT],[HLD],[LOUT],[QUICK_KEY],[START_KEY],[RSV],
[NUMBER_TAG],[RSV],[RSV],[RSV] [\r]
SSP,OK[\r]
[SRCH_INDEX] : Service Search Range
1 : Public Safety 6 : Air 12 : Special
2 : News 7 : CB Radio
3 : HAM Radio 8 : FRS/GMRS/MURS
4 : Marine 9 : Racing
5 : Railroad 11 : FM Broadcast
[DLY] : Delay Time (-10,-5,-2,0,1,2,5,10,30)
[ATT] : Attenuation (0:OFF/1:ON)
[HLD] : System Hold Time for Search with Scan(0-255)
[LOUT] : Lockout for Search with Scan(0:Unlocked/1:Lockout)
[QUICK_KEY] : Quick Key ( 0 – 99 / .(dot) )
[START_KEY] : Startup Configuration Key ( 0 – 9 / .(dot) )
[NUMBER_TAG] : Number tag (0-999 / NONE)
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
<COMMAND CSG>
Get/Set Custom Search Group
Controller → Radio
CSG[\r]
CSG,##########[\r] : Status of Each Search Range
Radio → Controller
CSG,##########[\r]
CSG,OK[\r]
########## (each # is 0 or 1) : 0 : valid / 1 : invalid
The Order of Range is as same as LCD Icon (1 – 10).
Get/Set current status of the custom search range.
This command is only acceptable in Programming Mode.
*It can not set all Custom Search Ranges to "0".