Unipulse F325 - Page 93

82
12 Interface
82
Interface
Chapter
12
- Actual load calibration
- Equivalent input calibration
- Hold ON
- Hold OFF
- Digital zero
- Digital zero reset
Host
F325
CB
N0B
Calibrating
CRNO
ID No.
ID
ID No.
0: Normal end
2 to 7: Calibration error No.
L: Calibration LOCK (calibration not possible)
R: Calibrating
Ter min at or
Host
F325
CV
N0V
Calibrating
CRNO
ID No.
ID
ID No.
0: Normal end
2 to 7: Calibration error No.
L: Calibration LOCK (calibration not possible)
R: Calibrating
Ter min at or
Set the rated capacity value before sending a command for actual load
calibration.
Set the rated output value and rated capacity value before sending a
command for equivalent input calibration.
Attention
Host
F325
CE
* No return data
CRNO
ID No.
Host
F325
CF
* No return data
CR
NO
ID No.
Host
F325
CG
* No return data
CR
NO
ID No.
Host
F325
CH
* No return data
CRNO
ID No.