Vaisala FS11P - List of Commands; PWD32 Command Set; Help; Table 16 Command Set

Chapter 4 _________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 111
List of Commands
PWD32 Command Set
HELP
By typing HELP, the operator receives information about available
commands.
Table 16 Command Set
Command
Description
OPEN
Assigns the line for operator commands.
CLOSE
Releases the line for automatic messages.
MES Number
Displays data message.
AMES Number Interval
Automatic message (with parameters Number
and Interval).
CLRS
Clears precipitation sums.
STA
Displays status.
PAR
Parameter message.
HIST Parameter
For Vaisala systems use.
INTV Time
For Vaisala systems use.
TIME hh:mm:ss
Set/Display system time.
DATE yyyy:mm:dd
Set/Display system date.
WPAR
Weather parameter message.
CHEC
Displays calibrator test signal.
ZERO
Displays zero and noise test status.
CAL
Calibrator_frequency
Calibration.
CONF Password
Updates configuration.
WSET
PRW reference values.
CLEAN
Sets clean references.
BAUD Rate
Commn._type
Baud rate setting
(Rate 300, 1200, 2400, 4800, 9600)
(Communication type E (7E1) or N (8N1))
DRY ON
Sets RAINCAP
®
dry offset.
WET ON
Sets RAINCAP
®
wet scale.
ACAL
Analog output calibration.
BLSC
Background luminance scale / enable.
RESET
Hardware reset by watchdog.