User's Guide _______________________________________________________________________
112 __________________________________________________________________ M211107EN-C
MES
After opening the line for operator commands (see section Entering and
Exiting Command Mode on page 106), a data message can be displayed
using the MES command. Refer to section Message Types on page 107
for message type descriptions.
The command format is the following:
MES Message_number
The valid range is 0 ... 7.
For example, when choosing the data message number 0, type the
following:
>MES 0
AMES
The AMES command defines the message, which PWD32 transmits as
the automatic message or as the default polled message. Refer to section
Message Sending Modes on page 94.
Weather-Related Commands
The following commands are used to display/set the weather analysis
parameters and results.
Weather parameter message
To Next Page
Loading...
