Vaisala FS11P - Figure 12 Fixing Sensor Arm with allen Screws; Figure 13 Fixing PWD32 with allen Screws

User's Guide _______________________________________________________________________
40 ___________________________________________________________________ M211107EN-C
6. Mount the sensor arm by aligning the holes at the end of the sensor
arm's forks with the threads on the back of the rear panel. Fix it in
place with four Allen screws. See Figure 12 below.
1002-037
Figure 12 Fixing Sensor Arm with Allen Screws
7. Attach the Precipitation Identifier PWD32 to the top of the sensor
arm so that the receiver and transmitter are pointing away from the
FSI102 interface unit. Fix it in place with four Allen screws. See
Figure 13 below.
1207-021
Figure 13 Fixing PWD32 with Allen Screws