User's Guide _______________________________________________________________________
48 ___________________________________________________________________ M211107EN-C
18. If the Obstruction Light option is mounted, lift the enclosure and
suspend it from the left-side hole in the rear panel. Install and make
the cabling as shown in Figure 23 below. Refer to Figure 25 on
page 50 for the wiring inside enclosure.
NOTE
The cable shield of the Obstruction Light cable must be properly
grounded in the cable gland of the interface unit's enclosure; see Figure
29 on page 56.
1001-110
Figure 23 Assembly of Sensor Arm
To Next Page
Loading...
