User's Guide _______________________________________________________________________
34 ___________________________________________________________________ M211107EN-C
The Foundation Kit included in the FS11P delivery contains the required
equipment for both mounting when casting the pad and mounting to an
existing surface. The triangle-shaped drilling template can be used as an
auxiliary device that has to be removed before mounting the base plate.
Mounting when Casting Pad
To mount the FS11P system while casting the pad, proceed as follows:
1. Screw on the three reinforcing plates to the lower end of the
foundation screws as shown in Figure 7 on page 35. To prevent the
plates from rotating after their correct position has been found,
destroy the threads above and below them by hammering.
2. Fix the drilling template to the upper ends of the foundation screws
with six M16 nuts.
3. Embed the assembly in the concrete foundation as shown in Figure
7 on page 35. If Background Luminance Sensor LM21 is installed,
any of the three sides of the assembly should be aligned so that the
adjustments of the LM21's bracket allow the desired viewing
direction for LM21.
4. After the concrete has set, remove the template.
To Next Page
Loading...
