User's Guide _______________________________________________________________________
194 __________________________________________________________________ M211107EN-C
4. Open the four screws (number 2 in Figure 56 on page 193) holding
the cover plate and remove it. The cover must to be carefully slid
upward in a small angle to pass the FSP103 card's edge.
5. Open the two screws (number 1 in Figure 57 below) holding the
FSC202 board in place and pull the board out carefully. Disconnect
the connectors (2) from the bottom part of the FSC202 board.
1207-016
Figure 57 FSC202 Screws and Connectors
6. Assemble the new FSC202 board (spare part for FS11P) back in
reverse order.
7. Turn on the power and battery switches. Configure the unit with
correct parameter settings using the commands described in section
Entering and Exiting Command Mode on page 69.
To Next Page
Loading...
