Vaisala FS11P User Manual

Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 69
CHAPTER 4
OPERATION
This chapter contains information that is needed to operate FS11P.
FS11P Present Weather Sensor is a fully automatic instrument that does
not need any regular operation by the user. The measurement parameters
set at the factory do not usually need to be changed.
The FS11P visibility messages are either sent automatically or polled by
the host computer.
The FS11P system parameters can be set with the SET command. Other
commands can be used to display system status and other maintenance
data. All commands can be given either through the Maintenance line or
the Data line. Commands given through the Maintenance line do not
interfere with the Data line visibility message sending.
FS11P Commands
NOTE
All command parameters must be separated from each other by a space
character an
d every command must end with pressing ENTER.
Entering and Exiting Command Mode
Before any commands can be given to the FS11P sensor, the
maintenance or data line of FS11P has to be assigned to the operator.
Otherwise it is assigned to automatic messages or polled communication.
The user enters the command mode with the command OPEN.
OPEN Command
If no device identifier (ID) is defined, type
OPEN

Vaisala FS11P Specifications

General

Brand	Vaisala
Model	FS11P
Category	Accessories
Language	English