Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 41
1001-106
Figure 14 Mounting Rear Panel of Radiation Shield
8. Attach the FSI102 interface unit to the rear panel of the radiation
shield (see Figure 22 on page 47). The upper end of the interface
unit is mounted by inserting the hook at the back of the interface
unit into the groove in the rear panel. The lower end is mounted
with two screws.
NOTE
If the tilting support has been removed due to the length of the mast, a
temporary tilting support is
needed.
To Next Page
Loading...
