User's Guide _______________________________________________________________________
64 ___________________________________________________________________ M211107EN-C
Maintenance Terminal Connection
Any computer equipped with terminal emulation software or a VT100-
compatible terminal with an RS-232 serial interface can be used as a
Maintenance Terminal for the FS11P sensor. The optional maintenance
cable QMZ101 (included in the FSA11 Calibration Kit) provides a 9-pin
D connector for the computer and a connector for FS11P. The external
maintenance connectors of the FS11P sensor are located on the right side
of the interface unit when looking at the unit from the door side. The
upper connector is for PWD32 unit and lower for FS11P (see Figure 35
below). The connector is protected with a cap. Replace the protective cap
after disconnecting the maintenance cable.
The maintenance cable QMZ101 can also be used for a connection with
the PWD32 maintenance interface. The external maintenance connector
of the PWD32 sensor is located at the side of the interface unit (see
Figure 35 below). For detailed information on the maintenance interface
of PWD32 Precipitation Identifier, see PWD22 User's Guide; refer to
section
Related Manuals on page 11.
1207-023
Figure 35 Location of External Maintenance Line Connectors
The following numbers refer to Figure 35 above:
External maintenance line connector for PWD32
External maintenance line for FS11
To Next Page
Loading...
