Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 71
CLOSE Command
The line can be released to automatic data messages with the CLOSE
command.
If no ID is defined the FS11P sensor answers:
FS11P LINE CLOSED
For example, if an ID is defined as A, the FS11P sensor answers:
FS11P-A LINE CLOSED
Available Commands
With the HELP command the operator can get information about the
available commands. By typing HELP Command the operator can get
information about a specific command.
The hierarchy and description of the commands are described in Table 9
below. In addition to the user level command set, there is a second,
advanced, in-depth maintenance and service level command set. The
access command to this advanced level is LEVEL 1. The command
prompt shows the current command set level. In the advanced level the
prompt is 1>.
Table 9 User Level Commands
Releases the port for message transmission.
Enables input character echo (default).
Disables input character echo. Set off when operating
with the RS-485 connection.
If the message number is not specified, FS11P displays
the default message without transmission frames.
FS11P displays all messages.
HELP command alone lists available commands. With a
command name as a parameter, the HELP command
shows information about that specific command.
Prints the status message, with the optional CHECK
parameter prints a short status check message.
Prints configuration parameters.
SET MESSAGE TYPE message_number
Selects the transmitted message type.
Selects the MITRAS Single Base emulation mode. The
data message, message frames, and polling format are
the same as they are in Vaisala MITRAS
SET MESSAGE TYPE MITRAS_DB
Selects the MITRAS Double Base emulation mode. The
data message, message frames, and polling format are
the same as they are in Vaisala MITRAS
SET MESSAGE TYPE FD12MSG2
Selects the FD12 message 2 emulation mode. The data
To Next Page
Loading...
