User's Guide _______________________________________________________________________
94 ___________________________________________________________________ M211107EN-C
Message Sending Modes
FS11P messages can either be transmitted automatically at preset
intervals, or polled by commands or polling strings at intervals
determined by the host computer.
Automatic Mode
In the automatic mode the FS11P sensor sends a predefined message at
selected intervals. The automatic and default polled message can be
defined with the SET MESSAGE TYPE command. For available
messages, refer to section
Message Formats on page 79. The format of the SET MESSAGE TYPE
command is as follows:
SET MESSAGE TYPE Message_number
The following command selects message 2 as the default automatic
message:
SET MESSAGE TYPE 2
The automatic message interval is selected with the command SET
MESSAGE INTERVAL. The message interval is given in seconds. An
interval of zero, which disables the automatic sending, is used when the
messages are polled. The command format is as follows:
SET MESSAGE INTERVAL Message_interval
The following command selects the message to be sent once a minute:
SET MESSAGE INTERVAL 60
The following command disables the automatic sending:
SET MESSAGE INTERVAL 0
The automatic message number is also the default number for the
MESSAGE command and polling.
To Next Page
Loading...
