Vaisala FS11P - Figure 62 Pushing Control Cable into Optics Head; Figure 63 Transmitter Resp. Receiver Module, Control

User's Guide _______________________________________________________________________
200 __________________________________________________________________ M211107EN-C
7. Pull the receiver/transmitter module carefully out of the head.
- Push the control cable from the center compartment side and
pull the module further out until access to the control cable
connector is possible. (Pull the receiver/transmitter module from
the optics head while simultaneously feeding in the control
cable).
- Receiver/Transmitter module is now pulled out to approximately
50%.
Figure 62 Pushing Control Cable into Optics Head
1207-026
Figure 63 Transmitter Resp. Receiver Module, Control
Cable Disconnected
The following numbers refer to Figure 63 above:
1
=
Hood thermistor cable
2
=
Control cable
3
=
Opening tool
8. Use the special tool to unlock the control cable connector and
disconnect control cable from the receiver/transmitter module